The SoundSkins Pro Mega Kit gives you 44 sq ft of 3-layer sound deadening for projects bigger than a pair of doors. Each sheet bonds rubber butyl, foil and closed-cell acoustic foam into one material, so you can quiet all four doors, the trunk and more without buying and layering separate products. It is also a lower cost per square foot than the smaller Pro kits, which makes it the practical choice when you are treating most of the car.
Buying four Two Door Kits to get the same coverage would cost $496. The Mega Kit gets you there for $412.
What 44 Square Feet Covers
Exact coverage depends on your vehicle and how much of each panel you treat, but in a typical sedan the Mega Kit handles all four doors (outer skins and access holes) and still leaves plenty for a second area, such as:
The trunk: Trunk floor, wheel wells and the trunk lid, where a lot of road and exhaust noise gets in and subwoofers cause rattles.
The front floor: Driver and passenger footwells, where tire noise and heat come through the floor pan.
Rear doors and quarter panels on trucks and SUVs: Larger doors and open cargo areas use more material, and the Mega Kit gives you room to cover them properly.
Planning the whole car, roof included? The Pro Plus Kit is sized for that.
One Material Instead of Two
Traditional sound deadening takes two steps: a butyl mat to stop panel vibration, then a separate foam layer to block airborne noise and stop rattles. SoundSkins Pro combines both. The butyl adds mass and kills resonance in thin sheet metal, the foil holds it tight to the panel, and the closed-cell foam on top absorbs noise and cushions trim panels. That means fewer steps, fewer products to buy and an install you can finish in a weekend. Learn more about how SoundSkins Pro works.
Tips for Large-Area Installs
Work at 50°F to 70°F. This is the recommended application range for the best bond.
Make paper templates for floors and trunk panels. Big, curved areas are easier to cut accurately from a template.
Clean every surface with isopropyl alcohol to remove dust and oil before applying.
Roll it down firmly so the butyl makes full contact with the metal, especially on ribbed floor pans.
Leave drain holes, seat bolt holes and wiring paths clear so nothing is blocked when you reassemble.
Frequently Asked Questions
How many doors does the Pro Mega Kit cover?
All four doors on a typical sedan, with material left over for the trunk or front floor. Larger truck and SUV doors use more material per door.
Can I use it on the floor and under carpet?
Yes. At 0.18" thick, it sits flat under factory carpet and helps block tire noise and heat coming through the floor.
Will it hold up in hot weather?
Yes. SoundSkins Pro is rated from -40°F to 356°F, so it stays in place in hot trunks, on floor pans and in summer heat.
Is it better value than buying smaller kits?
Yes. At $9.36 per sq ft, the Mega Kit costs less per square foot than the Two Door or Four Door kits and saves $84 compared to buying four Two Door Kits.
Is there a warranty?
Yes. SoundSkins sound deadening products come with a lifetime warranty against manufacturer defects.
Save by bundling on your sound deadening project with the SoundSkins Pro Mega Kit! This Mega Kit includes 4 roll of our best-selling SoundSkins Pro for a reduced price! This gives you enough material to cover:
- 4 doors and your most of the trunk of most standard sedan sized vehicles
- 4 doors and part of the floor of most standard sedan sized vehicles
- 2 doors and the full floor or full trunk of most standard sedan sized vehicles
and other similar projects!
SoundSkins Pro is a combination of 3 layers, acoustic foam, foil & rubber butyl (the black sticky stuff). This custom blend of materials allows you to layer any panels in your vehicle to reducing vibrations, loss of sound and improve heat rejection.
Large single sheets make it easy to apply and cut to size for any application.
The rubber butyl has a high adhesive level meaning it will never never fall off once applied correctly. The foam and butyl are both waterproof and heat proof designed to stand the test of time.
Consists of
4x Sheets 79" x 19" (rolled up)
0.18" Thickness
Coverage
44 sq ft
Weight
44lbs
Material
0.12" Foam 0.059" Butyl 0.0039 Foil Liner In Between
Used SoundSkins Pro on my 2013 F150 to sound deaden, and seal my door cavity. The results were a more solid door, significantly less vibration, and noticeably deeper midbass. SoundSkins Rings helped project the midbass woofers into the cab, losing less sound between the door and the panel. Such a huge increase in overall SQL. Best sound deadener I’ve used!
Purchased the Pro Kit for my 2020 Jeep Gladiator. It was enough material to do all 4 doors and floor panels front/back under the carpet. Also enough material left over to cover the rear floor section of my wife’s Jeep. I has no waste and used every bit of the material in the end.
I tested the decibel level in the Gladiator before and after. My noise reading went down 4 decibels after installing the SoundSkin. I was able to turn the music volume down 4-5 levels as well for more comfortable listening.
Easy product to install. However, when it comes to install, some of the butyl and foam already have air bubbles from the manufacturer. You'll have to use a needle to clear this issue. However, can't beat the 2 in one product. Would recommend to anyone. A huge difference in cabin sound.
Soundskin pro is the absolute best product I’ve ever used for sound treatment. PERIOD! It’s extremely easy to work with and definitely does more than any other on the market. While other have you pay money for each product that does a different job. Sound skin all ready has it all in one. The foam is a extra nice touch it’s great for in between panels. The foam gives some play where it holds tightly and prevents vibration. I’ve done my headliner of my car. Whole trunk. All doors and next will be the entire floor of my car. Only using sound skin for now on 😎
I love the product it’s easy to handle easy to cut if left outside to get a little softer. To do all four doors on a 2013 f150 inner and otter, it’s best to have more then 4 roles if looking to cover as much area as possible. To help with the outline and pattern I bought some clear adhesive furniture protector but Treysa the outlaw and the holes that need to be left open.
This stuff is awesome. I’ve tried other brands and don’t get me wrong the other brands are great, but this stuff just sounds and feels more solid. Worth every penny. This is an essential part of your car audio install.
I purchased this for my 2017 Toyota Highlander. I was surprised how easy it was to cut and apply the Soundskins Pro. I measured the sound before I did the floor and after, there is a total loss of 4db noise in the vehicle. The reduction in Boise is noticeable. Time to order more Soundskins Pro to do all 4 doors. Excellent product that I highly recommend.
Amazing product, I am a professional installer and by far I can say this is the best sound deadening material I've ever installed, I'm covering every single part of my 95 Toyota Supra. I would highly appreciate if you guys can help me out with a discount because I need to cover the back seats, trunk, sealing and also inside the fenders and firewall. Thanks in advance Soundskins team! 😃👌
Researched a lot of soundproofing products for three months and choose SoundSkin Pro for my 1997 Civic Hatchback. Love the performance. Makes a night and day difference.
Watched the videos and used the tips therein. Made the install easy and painless. The suggestion of material scissors and mineral spirits made all the difference. The sound difference in the car itself is spectacular!! Recommend anyone who wants better sound to get off their wallet and do this upgrade.
Combining 2 products into 1 saves a ton of time on installation. The acoustic foam doubles as a pad to keep panels from rattling against each other. Much more flexible then Dynamat and also significantly lighter. Worked fantastic for me and installed very well. Easy to cut as well.
It was easy to work with. You have to be a little gentle rolling it on To prevent ripping the acoustic foam. You’ll probably want to buy more than you think because I ended up finding new places I could put it. (4 pack for the win)
Covered most of the inside of the outer skin of the front doors, and 90% of the inner skin (covering a giant hole in the process). I now have multiple eargasms every time I crank it up! Very easy to work with and is obviously top quality materials.
I chose the SoundSkins Pro as it combines the foil and butyl of other products with foam for added sound dampening. The product was easy to handle and improved the sound of my stereo - even before my speaker upgrade.
When installing the product on your inner door I recommend either using a few pieces or buying the precut sheets for your vehicle. Taking a large sheet and trying to cut holes in all the right spots can be a bit of a challenge. For cutting purposes, you can get perfectly round holes by using large leather punches (e.g. 15mm).
I bought the Mega pro kit. I covered the cargo area of my rav4 and GTI. I also did of the doors on both cars. I covered about 35-40% of the outer door shell on all 4 doors of both cars and I have to say that while both cars benefitted from road noise reduction, the RAV4 benefitted the most. Reason being is that the GTI has very heavy insulation to begin with. Sitting in the backseat, I can easily say that the luggage area is very quiet (minus the wheel well area)
The RAV4 is much quieter inside while the GTI has better sound clarity from the speakers. I still have 1.2 rolls left and may need to purchase 1 or two more rolls to finish my job. I want to cover the wheel wells of both cars. Once that is done, I believe the cars will be at the perfect level that I'm looking for.
Thanks Soundskins for helping me reduce the road noise while improving the stereo quality in my rides.
One more thing, the Soundskins I ordered actually came with a defect from the factory, after pointing this out, Soundskins quickly righted this unfortunate situation. They definitely care about the customers! I will return to Soundskins for future work and will recommend them to others!
All Soundkins needs now is an external wheel well kit!
I loved how easy it was to install the SoundSkins pro! I can really tell a difference in noise levels and road noise as a whole. I was for sure that 70 feet would be enough to cover the whole interior of my single cab, but I was short about 40 feet. All together it’s an amazing product and I definitely would recommend and buy again! I only wish I took more pictures!
With the 4 piece pro kit I was able to do the trunk, ( floor and the surrounding walls) rear wheel wells, hatch back lid (in smaller pieces) both doors and the roof. And the sound difference is huge. 1 more pro kit and I can do the floors and firewall inside. That’s basicaly the entire inside of the car.
This is my second car ive applied sound deadener on, and it turned out perfect. I took my time and made templates by tacing the door panel and test fitting over and over to mark out all of the holes nicely. There’s few videos out there to show how its done properly, but i watched the soundskinsglobal tutorials on youtube (https://youtu.be/ujaxqr5fFakI) and it made the job so much easier. I took their advice on how to apply to the inside of the door, the outer panel, and also sound deadened the inside of my door panel and it is extremely solid. I knew i was buying top of the line product, but when i was done, i have so much more sound coming from the front end of my car compared to the back which I’m still working on. I used 2 rolls for all 3 layers of both front doors and the acoustic foam sounds great blocking out external noises. I am also deadening the rear deck, c pillars, trunk lid, license plate, and trunk. Time to order another 4 rolls to take it to the next level!
If you are on the fence about ordering this product over competitors higher priced stuff, place your order now. It works. Super strong adhesive backing and absolutely killed the road noise and exhaust drone coming from the back of my Mustang. I also installed in the doors and the stereo absolutely woke up the base hits really hard throughout the car. If you are doing a Mustang 4 rolls covers the trunk area and the two doors entirely. I hope to install under the seat pans and above the head liner to kill all the other tin sounding areas and any other road noise.
Great product.
The DIY process seems simple and easy for me. The result is amazing that midrange is much outstanding now and Bass is cleaner than before. They can really reduce noises from outside and road noise!
I feel more comfortable to enjoy music in my car now! :)
My sound skins pro kit worked perfectly and made a noticeable difference in both blocking out road noise and improving vibrations and rattles from my stereo. My trunk lid used to rattle horribly from my subwoofer but after applying the material to the trunk lid and throughout the trunk the rattle is completely eliminated! The only downside was that despite my best efforts to minimize waste and use the product somewhat sparingly, the pro kit was still not enough material to finish my entire interior due to my large trunk and overall interior space in my car. But I’m looking forward to buying another roll and finishing off my doors!
It’s thick but it didn’t hinder the installation or fit of OEM components such as door panels and trunk carpet panels. Very sticky so it stays where you put it. The top layer can get damaged “rip” so don’t treat it like a tool bench. Very good product.